MultiplexerThe term multiplexer has uses in several fields of application:
=In Electronics= In electronics, a multiplexer or mux is a device that combines several electrical signals into a single signal. There are different types of multiplexer for analogue and digital circuits.
=In Signal Processing= In digital signal processing, a multiplexer (often abreviated to "mux" or "muldex") is a device for taking several separate digital data streams and combining them together into one data stream of a higher data rate. This allows multiple data streams to be carried from one place to another over one physical link, which saves cost.
At the receiving end of the data link a complementary "demultiplexer" or "demux" is required to break the high data rate stream back down into the original lower rate streams.
It is usual to combine a multiplexer and a demultiplexer together into one piece of equipment and simply refer to the whole thing as a "multiplexer". Both pieces of equipment are needed at both ends of a transmission link because most communications systems transmit in both direction.
A real world example is the creation of telemetry for transmission from the computer/instrumentation system of a satellite, space craft or other remote vehicle to a ground system.
=In Digital Circuit Design=
In digital circuit design, a two-input multiplexer is a simple connection of logic gates whose output Y is either input A or input B depending on the value of a third input C. Its boolean equation is:
Y = (A and C) or (B and not C)
which can be expressed as the truth table:
=In Digital Circuit Design= In digital circuit design, a two-input multiplexer is a simple connection of logic gates whose output Y is either input A or input B depending on the value of a third input C. Its boolean equation is:
A B C | Y ------+-- 0 0 0 | 0 0 0 1 | 0 0 1 0 | 1 0 1 1 | 0 1 0 0 | 0 1 0 1 | 1 1 1 0 | 1 1 1 1 | 1or as the Karnaugh map:
Y C | 0 1 ---+----- AB 00 | 0 0 01 | 1 0 11 | 1 1 10 | 0 1Demultiplexers are sometimes convenient for designing general purpose logic. Basically, the inputs to the set of logic functions must be routed to the selection bits. Any function of the selection bits can be constructed by logically OR-ing the correct set of outputs.