Global system for mobile communications
The Global System for Mobile communications (GSM), formerly known as "Groupe Spécial Mobile" (French), is a world-wide standard for digital wireless mobile phones. The standard was originated by CEPT and further developed by ETSI as a standard for European mobile phones, with the intention of developing a standard for adoption world-wide.The standard is open, non-proprietary and still evolving. It has obtained wide support especially in Europe, where it is the major standard.
GSM differs from its predecessors most significantly in that both signalling and speech channels are digital. It has also been designed for a moderate level of security.
GSM employs time division multiple access between stations on a frequency duplex pair of radio channels, with slow frequency hopping between channels. GSM uses also SDMA and FDMA
GSM exists in four main versions, based on the band used: GSM-900, GSM-1800, GSM-850 and GSM-1900. GSM-900 (900 MHz) and GSM-1800 (1.8 GHz) are used in most of the world, excluding the United States and Canada. The United States and Canada uses GSM-850 and GSM-1900 (1.9 GHz) instead, since in the U.S. the 900 and 1800 bands were already allocated.
- GSM-900 uses 890-915MHz to send information and 935-960MHz to receive information.
- GSM-1800 uses 1710-1785MHz to send information and 1805-1880 to receive information
In Europe and other areas outside North America the GSM system initially used a frequency of 900 MHz, shortly afterwards the PCN network used the 1800 MHz frequency, nowadays the PCN networks are considered part of the GSM system and many phones are dual-band operating on 900/1800 MHz.
In GSM, a call is dedicated either as voice or data. A voice call uses a GSM specific codec to transmit the audio over a 9600 bit/s digital link to the base station.
A data call lets the user use the phone as a modem with 9600 bit/s bandwidth (some networks may also handle 14400 bit/s). All newer GSM phones can be controlled by a standardised hayes AT command set through a serial cable or a wireless link (irDA or bluetooth). The AT commands can control everything in the phone from ring tones to data compression algorithms. An extension to the GSM data capabilities, High Speed Circuit Switched Data (HSCSD), allows data transmission speeds up to 43.3 kbit/s by allocating several data channels into one logical link. Realistic bandwidth is usually about 30 kbit/s when standing still. Expect 10 kbit/s when moving.
| Table of contents |
|
2 WAP 3 GSM Services 4 See also 5 External links |
A GSM extension, called GPRS, allows packet switched data transmission. GPRS has been called 2.5G as it is viewed as a stepping stone toward pure 3G systems like UMTS, WCDMA or similar.
GPRS is backward compatible with GSM. This eases the migration path for a GSM operator, who can gradually upgrade the infrastructure to GPRS as the market expands.
Packet switched data under GPRS is achieved by allocating unused cell bandwidth to transmit data. As dedicated voice (or data) channels are setup by phones, the bandwith available for packet switched data shrinks.
A consequence of this is that packet switched data has a poor bitrate in busy cells.
The theoretical limit for packet switched data is approx. 170 kbit/s. A realistic bitrate is 30-70 kbit/s. A change to the radio part of GPRS called EDGE will allow higher bit rates of between 20 and 200 kbit/s.
GPRS packet switched data is IP-based. Each phone has one (or more?) IP addresses allocated. GPRS will store and forward the IP packets to the phone during cell handover (when you move from one cell to another). TCP's inability to differ between radio noise induced pauses and network congestion makes the protocol unsuitable for GPRS (or any radio based IP traffic). A radio noise induced pause will make TCP (unnecessarily) throttle back its transmission speed.
From the user's point of view, GPRS is a wireless extension of data networks. It can access to data networks, such as IP based networks like public internet, private intranet, IPv4 and IPv6 protocols, and X.25 based networks.
GPRS upgrades GSM data services providing:
GPRS
There is also for data transfer EDGE and UMTS systems.
WAP and its transmission layer protocol, WTP, use UD/IP to solve this problem. Application developers creating a new mobile IP based protocol can
GSM has been defined with the main purpose of voice services. Operators offer also data services at speeds of 9,6 and 14,4 kbit/s. Although a cellular network can never be regarded as completed, today the operators can less and less compete with coverage area or quality of the network. However, in these days the data services start to play a big role in operator business.
GSM service called High Speed Circuit Switch Data Service (HSCSD) offers data services at speed up to 57,6 kbit/s, depending on the multislot usage. Also this year some advanced operators will launch a new data service named General Packet Radio Service (GPRS), which enables data communication in the first phase at speed of 9,1-40,2 kbit/s, depending on the possible multislot usage and the coding scheme used. Also short message service and a set of value added services are specified in GSM system.
Global System for Mobile communication (GSM) is a cellular network typically offering a nation wide coverage depending on the operator. With the possibility of international roaming GSM user can use mobile services also globally. Also national roaming is supported by GSM.
The GSM network consists of cells. The coverage area of each cell is different in different environments. Macro cells can be regarded as cells where the base station antenna is installed in a mast or a building above the average roof top level. However, small cells or micro cells are cells where the antenna height is under the average roof top level. Thus the cell radius can vary depending on the antenna height, antenna gain and propagation conditions from couple of hundred meters to several tens of kilometers. Officially 35 km is the longest distance GSM specification supports, though the specifications define an extended cell, where the cell radius could be double. Also indoor coverage is supported by GSM.
Indoor coverage can be built by using power splitters to deliver RF signal from the antenna outdoors to separate indoor antenna distribution system. When all the capacity of the cell is needed indoors, e.g. in shopping centers or airports etc., the indoor coverage can be built by using antennas only inside the building. In suburban areas the indoor coverage is usually origin by the inbuilding penetration of radio signal, not by a separate indoor antenna system.WAP
GSM Services
See also
External links
This content should be merged into the main article at some point:
